Installation

Wall Mount Method

1. Use percussion drill to make four holes on the wall following the pattern in the above diagram.
2. Push the wallboard anchors to the holes.
3. Hold the REPEATER and push against the wall. Align the 4 holes on the REPEATER with the anchor holes.
4. Drive two screws into the holes on the top line. Do not fully tighten the screws.
5. Drive the other screws into the two holes on the bottom line. Do not fully tighten the screws.
6. Check REPEATER alignment and tighten the 4 screws one by one.
7. Ground the REPEATER properly to complete the installation.